To clarify: I'm not affiliated with FanControl but am following the issue thread on github. Specified in the corresponding Arch Linux package.First of all: Thanks Martin for responding and even showing interest in this issue at all, because it is quite obscure and only shows up for a small portion of users. License, except for the contents of the manual pages, which have their own license The website is available under the terms of the GPL-3.0 Using mandoc for the conversion of manual pages.
Package information: Package name: extra/lm_sensors Version: 1:3.6.0.r41.g31d1f125-2 Upstream: Licenses: GPL, LGPL Manuals: /listing/extra/lm_sensors/ Table of contents Generic term for "fan speed control", regardless of the actual In computers are based on pulse width modulation. The term "PWM" is used because most fan control systems See fancontrol(8) for additional information. Opportunity to establish mappings between fans and temperature inputs,ĭefine the temperature range over which the speed of the fan should beĪdjusted dynamically, the minimum speed at which the fan should spin, etc. System based on temperature measurements. Lastly, pwmconfig will enter in fancontrolĬonfiguration mode (unless you decide to skip that part.) In this mode, youĪre invited to enter several parameters which will determine how theįancontrol daemon regulates the speed of one or more fans in your Pwmconfig can generate a detailed correlation, to show how a givenįan is responding to various PWM duty cycles. When a connection is established between a PWM control and a fan, Installed, even if your sensor chip supports PWM. Note that many motherboards do not have PWM circuitry (PWM) controls, and tests each one to see if it controls a fan on your Pwmconfig searches your sensors for pulse width modulation
There is no significant system load, to minimize the risk of It is strongly recommended to run pwmconfig at a time when Motherboards and fans, it shouldn't be blindly trusted. Spinning when they are supposed to, but due to the diversity of available pwmconfig does its best to check that the fans are Verify that all fans are running at normal speed after this program This may cause your processor temperature Pwmconfig will attempt to stop your fans, one at a time,įor approximately 5 seconds each. Pwmconfig - tests the PWM outputs of sensors and configures
0 kommentar(er)
